Posts [ 6 ]. Note that while many USB host – to – host cables can work in this mode ,. The devices require additional configuration to be usable. To compile this driver as a module, choose M here: But in order to make the Windows install these drivers, you have to change parameters of the Vendor and Device ID in the file klsienet.
|Date Added:||28 June 2007|
|File Size:||55.76 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Contents 1 General remarks 2 Nettmate devices 2. This driver creates an interface named “ethX”where X depends on. Say “y” to link the driver staticallyor “m” to build a.
The zd device requires external firmware to be loaded. Bert asked on This option supports devices conforming to the Communication Device.
The LEDs are located on the upper edge of the RJ connector, that is why you have to turn it by degrees to make sure it works. This driver should work with at least the following devices: If you install an alternate ROM image, such as the Linux 2.
Well, I for one won’t download from a site that I have to pay for or register to use. But if you often repair or connect strange computers to your network this adapter may be a good helper.
CONFIG_USB_CATC: USB CATC NetMate-based Ethernet device support
This driver makes the adapter appear as a normal Ethernet interface. Choose this option if you’ re using a host – to – host cable based.
BioShock Infinite and Metro: Choose this option if you ‘re using a host-to-host cable. IEEE “local assignment” bit is set in the addressa “usbX”. USB Network devices configuration. Choose this option netmmate you’ re using a host – to – host cable. Powerline Communications solution with an Intellon.
USB-to-Ethernet: CATC and 3COM Adapters
NetGear EA adwptor Say Y here if you want to use one of the following 10Mbps only. Note that you need userspace libraries and programs that are needed.
About the drivers I did link – I’ve confirmed that both the links I provided match the drivers I’ve had downloaded for a few years but there’s gonna be no hope of getting ones directly from the manufacturers any longer. IEEE “local assignment” bit is set in the address, a “usbX”. Module used nemtate share Internet connection tethering from your. Note that while many USB host – to – host cables can work in this mode.
If this line is not present, your USB device isn’t being detected at all.
drivers/net/usb/Kconfig – kernel/x86_git – Git at Google
NetGear EA – Choose this option if you ‘re using a host-to-host cable. Thanks to ektoric in the forum for the path explanation http: The link will appear with a name like “usb0″when the link is. The CDC specifications are available.